IDENTIFY YOU

Name
Password
	Pass forgotten?

• Or register you here

• ADHERE TO planetpal.NET

Adhere to benefit from our advantages !

• Directories
• Catalogues
• See our prices

GUIDE TECHNICAL

• Wood Pallets
  • Complete description
  • The pallet
  • Types
  • Elements
  • Assembly
  • Characteristics
  • Transport
  • Light heavy ½heavy
  • Nails (fr)
  • Drying (fr)
  • Wood Standards
• Plastic pallets
• Others
• Choice of materials

• Glossary

Principal characteristics of the pallet

The cutting of angles

The 4 angles of a palette can be rights (one speaks then about palette to square corners).

The interest of the cutting of angles is:

to protect the plastic covers because they tend to tear when the angle is too lively (90 °)

to facilitate the transport of palettes by limiting hang on them on angles.

The good length of the bevel (L) goes from 15 to 30 mm ( minimum 10 mm). The angle of cutting is 45 °.

The cutting of the angles of the palette takes place when this one was completely gone up.

One cuts at the same moment the parts of the top deck, of the stringerboard, the block, and the bottom deck. 4 corners are cut by machines after location and immobilization of the palette.

	TD = Top deck
	S = stringerboard
	BD = bottom deck
	BA = bevel of angles

There are as well the blocks that were cut before (wooden agglomerated
blocks), these last ones are cut in all the angles, what allows
in more a guide of the forks of the wagon at the time of the penetration.
These blocks do not prevent the operation of cutting of angles
of all the parts at the same moment ( top deck, stringerboard
and bottom deck).

top sight :

block that were cut before :

• PUBLICITY

Your publicity on our banner page !